Rural Engineering Department

Rural Engineering Department has published Tender For Road Construction Work From Bahoranpur Pitch Road To Anil Patels House To Vansh Narayans House - Earth Work in cutting or in embankment in ordinary soil excavation to be the form of regular pits not exceeding 1/2 meter (20) distance as directed by the E/I.as per si.no. 253 Carted from 6.0 Km distance 2 Excavation in foundation in ordinary soil (Loam clay or sand) includind lift up to 1.5 m. and lead up to 30 m.and includingetc.complete. same as per SI.No.251. 3 Concrete with 4 cm.gauge brick ballast,sand of 1.25 F.M.and cement in proportion of 12:6:1 in foundation and under floors including supply of all material laborT& P etc.required for proper completion for the work.as per S.I no. 273- 4 M-150 Brick Work in 1:4 Cement and sand of 1.25 F.M.morter in Foundation and plinth including S/O all material labour T&P.etc.required for proper completion of work..same as perS.I.No.305. 5 12 mm.thick plaster with cement morter in proportion of 1:4 cement and sand of 1.25 F.M.over brick work minimum thickness not to be less than 10 m.m.includings/o all materials labour andT&P.required for proper completion of the work.as per SI.No.584 6 Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheeled roller complete as per T.S. clause 401. 7 Providing and laying of Rubber moulded Interlocking concrete block pavement havingthickness 80 mm including leveling and dressing of surface To required level and slope spreading and moisting 30 m.m thick local sand on bend filling joints with local sand etc. for proper complition of work as per drawing and T.S. clause 1504Grey 8 50 % Red 9 Laying cement concrete PCC road with 2cm gauge approved stone ballast approved coarse sand and cement in the proportion of 1:2:4 incliding supply of all materials labour and T and P etc required for proper completion of work . 279(b) 10 S/Fixing of infomataryM.Ssign board Size (1.2x0.90) Made of 18 mm gauge M.S.Sheet fixed in ISA 40x40x5 mm frame supported in back side by 40x5 mm fiat iron on all four side along with two vertical pont of 2.15 mt from bottom of frame of angle iron ISA 40X40X5 mm with 150 mm long horizontal lag at bottom braded with 40x5 mm flat iron ellectrically welded and pointed with one coat red oxide primer S.S. NO. 503 . Last date of submission for this tender is 2025-07-30. This is a Road Work tender in Varanasi, Uttar Pradesh