Irrigation Department

Irrigation Department has published Tender For Estimate For Renovation Of Service Road Of Jarakhar Dy. From Km. 2.600 To 3.500 - Cutting Heavy Under and bushes upto 7.5 cm dia including . 2 WBM Grading 2 providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing , rolling with smooth wheel 80-100 KN in stages to proper grade and camber, applying and brooming, stone screening/ biding materials to fillup the interstices of course aggregates, watering and compacting to the required density grading 2 as per MORD technical specification clause 405 3 WBM Grading 3 providing, laying,spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing , rolling with three wheel 80-100 KN static roller in stages to proper grade and camber , applying and brooming, crushable screening to fillup the interstices of course aggregates , watering and compacting to the required density grading 3 as per MORD technical specification clause 405 4 Providing and applying Prime coat with bitumen emulsion (S.S.-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70-1.0 kg/sqm using mechanical means as per Technical Specification Clause 502 5 Providing and applying Tack coat with Bitumenusing Bitumen V.G.-10 distributor at the rate of 0.25 to 0.30 kg per sqm on the prepared dry and hungry bituminous surface cleaned with Hydraulic broom as per Technical Specification Clause 503. 6 Providing laying & rolling of open graded Premix carpet of 20 mm thickneess composed of 13.2 mm to 5.6 mm aggregates using VG-10 grade bitumen to required line, grade and level to serve as wearing course on a previously prepared base, including spreading mixing in a suitable plant, laying and rolling with three wheel 80-100 KN static roller in capacity, finished to required level and grades to be followed by seal coat-Technical Specification Clause 408 7 Providing and laying Seal coat by mannual means with VG-10 Gr.grade bitumen sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type Cas per Technical Specification Clause 510 8 Providing and laying Hot applied thermoplastic compound 2.5 MM thick including reflecorising glass beats @ 250 per Sqm. Area thickness of 2.5 MM exclusive of surface applied glass beats as per IRC : 35 the finished surface to be level, uniform and free from streaksand holes at site 9 Brick edging on road with m-150 class bricks on edge 3 wide and 4-1/2 deep laid with mud mortor,finished to the required temples in proper alignment & also dressing ramming the excaveted earth as directed by engineer in charge. 10 Providing and fabricating MS sign Board of size 4×3 using ISA 40×40×6 mm and 25x3 mm flat iron bracing with 18 SWG MS sheet with one coat of red oxide primer to fixed at 11 level of minimum 3 from round and 2 deep into the ground with 3 angle cut and turned to opposite side to make a hold fast and steel angle i/c all cost of all labour, material, Paiting letter writting etc. as per direction and fully satisfaction of Engineer in charge. . Last date of submission for this tender is 2025-10-02. This is a Road Work tender in Hamirpur, Uttar Pradesh