Tamil Nadu Generation And Distribution Corporation Limited

Tamil Nadu Generation And Distribution Corporation Limited has published Tender For Providing Weathering Tiles To The Open Terrace,Electrification Works To The Section Office And Collection Counter Along With Fan & Light ,And Providing Angle With Galvalume Sheet To The Consumer Shelter At The Proposed To Ae/O&M Guindysection Officeat Guindyindustrial Estate; 1 Providing weathering course with one course of pressed tiles of size 20 x 20 x 2cm Embeded in CM 1:3 12mm thick & pointed with same mortor mixed with crude oil 10% weight of cement used over a bed of brick jelly, lime concrete of 80mm thick with ratio of 32:12.5 cft, (no sand) with the required slope and beaten with wooden beaters including cost of all materials, curing, labour lead lifts etc., complete. 2 Supplying & fixing of 4 22 watts LED light & Fitting complete with PVC roundblocks on ceiling or wall with LED tube with PVC unsheathed copper leads from terminals to the fitting. 3 Supply and 2 run of 2.5 sqmm (36/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100VGrade and earthing wire 1.5 sqmm (22/0.3) in suitable PVC rigid pipeconcealed in wall and ceiling with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour includingcost of material, lead, lift, labour etc., 4 Supplying & fixing of 48 Ceiling Fan Crompton High Speed (Crompton / Equivalent) including cost of all materials, labour, lead, lift etc., complete. 5 Supplying and fixing 4 nos of 6A 3pin combined flush type wall socket with 6A flush type switch on suitable PVC box including cost of all materials, labour, lead, lift etc., complete. 6 Supplying and fixing of 8 way single pole and neutral MCB sheet steel enclosure industrial type Distribution board 1 no. 40 A four pole for incomer 1 Nos. 10 A, 6 Nos 16 A, 1 No 20 A single pole SPMCB outgoing in wall surface and making good of the concealed portion with earth connection only. 7 Supplying and fixing powder coated aluminium Partition fullypaneled with 9mm thick both side prelaminated boards (Novapan or equivanent) and 5mm thick plain float glass (Modi, Saint Gobin or equivalent) using aluminium, box section 63x38.4x2mm for verticals and horizontals inclduing aluminium grill, cost of all materials, labour, lead, lift, T&P, etc., complete. 8 Supplying fabricating and fixing in position anodised aluminium door door half glazed & half PLB using aluminium box section 45x45x2mm for top, middle and sides, 100x45x2mm for bottom, top half fixed with 5mm thick pinnedhead glass [Modi, saint Gobin or equivalant] and bottom with 9mm thick both side prelaminated boards [Novapan or equivalaent], approved quality Mortice lock, aluminium handles at front and back, pivot at top and bottom door stopper etc., including the cost of all materials, labour, lead, lift, T&P etc complete. 9 Earth work excavation and depositing on bank with initial lift of 2 m for foundation in hard shift clay shift black cotton hard red earth shalles murram stones earth & earth mixed with small size boulders including labour lead lift T & P etc. complete 10 Filling with river sand complying with std. specification for filling for foundation including watering consolidation etc. the rate inclusive cost of sand labour for filling ect. Complete 11 Providing PCC 1:4:8 using 40 MM HBGS jelly for base and leveling concrete including cost of all materials labour lead lift curing etc. complete. 12 Supplying fixing of structural steel/hollow sectionsas directed by engineers at site for roof truss works including cost of all materials labour, lead, lift painting the channel etc.,complete. 13 Roofing with Galvalume sheets of 0.50 mm thick including cost of U orJ bolts & nuts bitumen washers etc including cost of material,lead,lift, etc., complete. . Last date of submission for this tender is 2025-07-22. This is a Tile Flooring tender in Guindy, Tamil Nadu