Indian Army

Indian Army has published Bids Are Invited For 1 Total Quantity : 1--1 Structural Of Design: Provn Of Defi Accn For 29 Coy Asc ( Sup ) Type C Under Ge ( West ) Ferozepur Cantt ( Amwp 2021-22 : List Iv / Ser No. 07 ) 1. Basic Group Shed ( Incl Sugar & Salt ) = 1009.19 Sqm 2. Lpg Shed= 293.61 Sqm 3. Fol Shed= 437.27 Sqm 4. Basic Group Shed ( Misc ) = 432.70 Sqm 5. Labour Amenity Room= 84.28 Sqm 6. Shed For Petrol Oil Greases Other Than Lubs= 1530.15 Sqm 7. Shed For Lubricants ( Incl Office ) = 632.25 Sqm 8. Inspection Shed For Fresh= 177.63 Sqm Design Parameters ( A ) Reinforcement Steel For All Rcc Work Shall Be Tmt Fe 500 / 500D Grade With Minimum Elongation 16% And 14.5% Respectively. ( B ) Grade Of Concrete Shall Be M-25 ( Min ) For Normal Structure And M-30 For Water Retaining Structure. ( C ) Sbc Of Soil As Per Soil Testing Report Obtained From E-2 ( Design ) Section Of Hq Cejz, Jalandhar Cantt. In Case Of Change Of Bearing Capacity Observed At Site During Execution, The Foundation Will Have To Be Redesigned By The Consultant At No Extra Cost To The Department. ( D ) Cover To Reinf In Rcc Shall Be As Per Is:456-2000 For Moderate Explosure Conditions. ( E ) Structural Design Shall Be In Conformity To Relevant Latest Version Of Is Code Such As Is-456, Is-876, Is-1893 ( 2016 ) And Is-13920 ( 2016 ) , Nbcs Etc. ( F ) Bldg Shall Be Designed For Earthquake Load As Applicable As Per Is-1893 ( 2016 ) & 13920 ( 2016 ) For Zone-Iv. ( G ) Any Other Parameter Not Mentioned Above But It Is Required To Be Taken Care Of While Carrying Out Structural Design And Detailing As Per The Indian Standards Is Deemed To Be Included. Notes:- ( A ) The Firm Should Be Approved In Mes. ( B ) The Firm Shall Provide Structural Drawings For Approval Of Mes For The Bldgs. ( C ) The Firm Shall Submit The Conceptual Alternatives / Line Plans For Approval Of Mes. ( D ) The Firm Shall Get The Structural Drgs Vetted From Iit / Nit / Govt Engineering College. ( E ) The Consultant Shall Submit The Soft And Hard Copies Of Following Documents To E2 ( Design ) Sec:- ( I ) Submission Of Complete Set Of Structural Drawing On Reproducible Film. ( Ii ) Two Set Of White Paper Prints Duly Vetted As Per Para ( D ) ( Iii ) Detailed Design Report With Calculations, Staad Files, Including References Etc. ( Iv ) Structural Drawing On Autocad ( V ) Design Philisophy & List Of Codes, Bis Publication Followed.. Last date of submission for this tender is 2022-06-17. This is a Bearings tender in Jalandhar, Punjab