Munitions India Limited

Munitions India Limited has published Bids Are Invited For 1. APPLY A LIGHT COAT OF SILICONE COMPOUND SPEC MIL-C-21567-A-1973 INDIGENOUS EQUIVALENT MATL SILICONE GREA SE TO IND/ME/989 (PROV) (LATEST ISSUE TO BE FOLLOWED) TO NOSE THREADS, SILICONE COMPOUND TO BE COMPATIBLE WITH EXPLOSIVE COMPOSITION 2. RETOUCH SURFACES WHERE PREVIOUS COATING IS DAMAGED, EXCEPT DRIVING BAND AND OBTURATOR, USING GUNKOTE TO KALGARD SPEC. 16.2 (SEE NOTE3). * 3. BOURRELET NUBS, AFTER RETOUCHING OF PAINT, SHALL PASS 6.0984 MAX. DIAMETER: RING GAUGE (154.90) 4. STANDARD ZONE IS ZONE 3. FILLED SHELL WITHOUT FUZE GRUMMET OR LIFTING PLUG WITH OBTURATOR 5. FOR FILLED MARKING AND MASS ZONES DETAIL REFER TO DRG N№ 105-9110 6. CHEMICAL CONVERSION COATING CLASS 1A TO SPEC MIL-C-55410 (ALKROME N№ 140-2) CAN BE USED FOR TREATMENT OF THE ALUMINIUM BOAT TAILS TO RETOUCH SURFACES, WHERE THE PREVIOUS COATING IS DAMAGED 7. COLD PHOSPHATE TO SPEC NA 257/83 CAN BE USED TO RETOUCH SURFACES WHERE THE PREVIOUS PHOSPHATING COATING IS DAMAGED. 8. LIFTING PLUG (WITH WASHER) TO BE TORQUED 10-12 Nm DIS-ASSEMBLY TORQUE TO BE NOT LESS THAN 10 Nm. FIT SCUFF PROTECTOR OVER LIFTING PLUG 9. A TOLERANCE OF±50g 15 PERMITTED ON ZONE LIMITS 10. USE APPROX. GRAM GRAPHITE POWDER ON MATING SURFACES OF BASE BLEED MOTOR AND SHELL THREADS (GRAPHITE TO SPEC. CS 5086) 11. BASE BLEED MOTOR TO BE TORQUED 170 Nm MΙΝ/190 Νm ΜΑΧ, 12. BASE BLEED MOTOR/SHELL GAP TO BE 0.05+0.61. 13. FOR DYNAMIC BALANCE, SPECIFICATION FOR ACCEPTANCE REFER SPEC 04-1320-2452-0-42002. Total Quantity : 1870. Last date of submission for this tender is 2025-08-27. This is a Cutting Crimping And Punching Tools tender in Chandrapur, Maharashtra