Local Self Government Department

Local Self Government Department has published Tender For General-Cheriyamundam Gp (Project.No.248/2025-26)-Take A Break Renovation- General Civil Work- 2 2.8.1:Earth Work In Excavation By Mechanical Means (Hydraulic Excavator) /Manual Means In Foundation Trenches Or Drains (Not Exceeding 1.5 M In Width Or 10 Sqm On Plan), Including Dressing Of Sides And Ramming Of Bottoms, Lift Up To 1.5 M, Including Getting Out The Excavated Soil And Disposal Of Surplus Excavated Soil As Directed, Within A Lead Of 50 M.All Kinds Of Soil 3 4.6.1:Providing And Fixing At Or Near Ground Level Precast Cement Concrete In Kerbs, Edgings Etc. As Per Approved Pattern And Setting In Position With Cement Mortar 1:3 (1 Cement : 3 Coarse Sand), Including The Cost Of Required Centering, Shuttering Complete.1:1½:3 (1 Cement: 1½ Coarse Sand(Zone-Iii) Derived From Natural Sources: 3 Gradedstone Aggregate 20 Mm Nominal Size Derived From Natural Sources). 4 50.10.2:Steel Work For Purlin/Single Section With G I Pipes Including Cutting, Hoisting, Fixing In Position And Applying A Priming Coat Of Approved Steel Primer, Including Welding And Bolted With Special Shaped Washers Etc. Complete 5 Od484298/2025-2026:Providing And Fixing Precoated Galvanised Iorn Profile Sheet (Size, Shape And Pitch Ofcorrugation As Approved By Engineer In Charge) 0.35 Mm (+0.05%), Total Coatedthickness With Zinc Coating 120 Grams Per Sqm As Per Is:277, In 240Mpa Steel Grade,5-7 Microns Epoxy Primer On Both Side Of The Sheet And Polyester Top Coat 15-18Microns. Sheet Should Have Protective Guard Film Of 25 Microns Minimum To Avoidscratches During Transportation And Should Be Supplied In Single Length Upto 12 Meteror As Desaired By Engineer In Charge. The Sheet Shall Be Fixed Using Self Drilling /Selftapping Screws Of Size(5.5X55 Mm) With Epdm Seal, Complete Upto Any Pitch Inhorizontal/ Vertical Or Curved Surfaces, Excluding The Cost Of Purlins, Rafters And Trussesand Including Cutting To Size And Shape Wherever Required. 6 13.60.1:Wall Painting With Acrylic Emulsion Paint Of Approved Brand And Manufacture To Give An Even Shade:Two Or More Coats On New Work 7 13.61.1:Painting With Synthetic Enamel Paint Of Approved Brand And Manufacture To Give An Even Shade:Two Or More Coats On New Work 8 10.25.2:Item Shifted To Sub Head 14 As Item 14.73Item Shifted To Head 14 As Item 14.74Steel Work Welded In Built Up Sections/Framed Work, Including Cutting, Hoisting, Fixing In Position And Applying A Priming Coat Of Approved Steel Primer Using Structural Steel Etc. As Required.In Gratings, Frames, Guard Bar, Ladder, Railings, Brackets, Gates And Similar Works. Last date of submission for this tender is 2026-05-18. This is a Earth Work tender in Malappuram, Kerala